Home » News » How to disinfect the mask in a temperature and humidity test chamber

How to disinfect the mask in a temperature and humidity test chamber

Views: 51     Author: Site Editor     Publish Time: 2020-04-16      Origin: Site

The number of infections is increasing as the corona-virus pandemic continues, but supplies of face masks are proving increasingly scarce. In response, both the German government and America president Donald Trump recommended that the masks be sterilized and then dried so they could be reused. How to sterilize and dry the mask? Sanwood technology's temperature and humidity test chamber can solve the above problems.


disinfect mask


The Federal Ministry of Health now recommends a maximum of three times uses of a respirator with a filtration function (FFP2 and FFP3) . After about three uses, bacteria will attach on the surface and then penetrate into the last layer of filter cotton, so that the mask can no longer be used. But we can purify them by properly heating of them. The drying chamber is able to perform this stage without lowering the protection level. 


The Federal Ministry of Health recommends that masks be exposed to dry heat of 65 to 70 degrees Celsius for 30 minutes, as this will inactivate the SARS-CoV-2 virus. "The measure is likely to be used nationwide. The decontamination process will eliminate pathogens, including corona-viruses, " the press release said. However, it is important that the face mask to be sterilized has a CE Mark to ensure that the material and structure can withstand the process.


disinfect mask


Studies conducted by the Federal Ministry of Health have shown that masks covering the nose and mouth can also be reused if they have been properly reprocessed at temperatures ranging from 65 to 70 degrees Celsius. The operating room is the only place where protective equipment can not be reused. This process is suitable for the equipment worn in daily hospital work.


Controller


Sanwood temperature and humidity test chamber has different specifications like Bench top type, standard type,Landing type, Walk-in type, to meet the different needs of customers. Here, from the single size of the mask, we judge that it is suitable for Bench-Top Type Temperature Humidity Chamber. The temperature of this test chamber is -40 °C ~ 150 °C, humidity range: 20 ~ 95% RH with small volume (22.5 L), low noise,which is suitable for office or small laboratory use. Sanwood self-developed controller is capable of simulating a dry heat environment of 65 to 70 degrees Celsius for 30 minutes.


small temperature test chamber


What do you think of this test or do you have any other new idea on face-mask using? If you have any questions about how to disinfect your mask, please contact us:E-mail:info@sanwood.cc and we will work out a solution for you. 


Leave Message
Contact Us

Guangdong Sanwood Technology Co.,Ltd

UV Lamp Weathering Test Chamber

About Sanwood

Contact Info

 Tel: +86-769-81181588
 E-mail: Info@sanwood.com

 Add: 
No.98 Changtian Road,Changping Town,Dongguan 523561, Guangdong, China
Leave a Message
Leave Message
Copyright © 2024 Guangdong Sanwood Technology Co.,Ltd
All Rights Reserved.

Site Map
We use cookies to enable all functionalities for best performance during your visit and to improve our services by giving us some insight into how the website is being used. Continued use of our website without having changed your browser settings confirms your acceptance of these cookies. For details please see our privacy policy.
×